Configuring Radius Network MAC Address

Reaching the settings and configuration page for your network requires a few simple steps. First, navigate to the settings and configuration page and enter your ID and Password. This information is usually available beneath the router, in its manual or on the box it came in.

To create an Authorization policy that checks for both membership of an Active Directory (AD) group and device membership in 'Local Hosts', follow these steps:

1. Reach your router's dashboard via 192.168.1.1 by taking the following steps.

2. The policy should be using the previously created Identity Store Sequence that includes both AD and Internal Hosts.

3. Create an Authentication policy that allows MAB (PAP/ASCII > Detect PAP as Host Lookup) and the protocol you are using for AD authentication, usually PEAP or EAP-MD5.

To create all hosts/static MACs under Users and Identity Stores > Internal Identity Stores > Hosts:

1. Create an Identity Store Sequence that includes both AD and Internal Endpoints/hosts.

2. However, in addition, under Security > Layer 2 > you need to check 'Mac Filtering.' Then under the AAA servers tab, make sure your ISE server(s) is listed under both authentication and accounting.

To configure your WLAN settings with the appropriate 802.1x settings:

1. You configure your WLAN settings with the appropriate 802.1x settings.

2. I haven't done it with ACS but it should be similar to ISE: 'radius network mac address'

Radius network mac address